EasySDR settings

This page only opens on this computer. Listeners use the station page on port (open it here).

On the air

#	Address	Tuned to	Time

Station

Station name Callsign Operator Location Grid square Antenna Contact (web page or email)

Description Message shown to listeners

Receivers

Tick the devices to share and the range each one covers. An SDRplay covers up to 8 MHz at once and an RTL-SDR up to 2 MHz; an RX-888 covers all of HF.

Also share the receivers SDRplay Tuner is already running on this computer

Listeners

Listeners at once Listeners from one address Session length, minutes (0: no limit) Wait before listening again, minutes "Still listening?" after, minutes

Each listener uses about 60 kbit/s of your upload (audio and waterfall).

What listeners may use

No audio in the FM broadcast band (87.5–108 MHz) No audio in the AM broadcast band (530–1700 kHz)

Rebroadcasting commercial stations online can raise copyright questions in some countries. It is your choice.

Blocked addresses, one per line (1.2.3.4 or 1.2.3.0/24)

Internet and the station list

Public port Settings page port

On your router, forward TCP port to this computer. A port change takes effect when EasySDR restarts.

List this station on w2jkt.com/websdr.html

You run this station independently and are solely responsible for it, for what it receives and streams, and for following the law where you are. W2JKT does not monitor, review or filter stations; the list shows them as they are.

To appear on the list, register this station once:

I understand

Your email (not shown on the list)

Advanced

Directory address